Impact Sand Making Machine Frequently Asked Questions

Impact sand making machine is also known as: vertical shaft impact crusher. It can be widely used in cement, mining, refractory materials, mineral processing, metallurgy, building materials, aggregate, bauxite clinker and so on. In the production process of impact sand making machine. If some problems and failures often appear, it will affect its production efficiency and effect. It is worth noting that: problems often appear because of improper maintenance in the production process. If the impact sand making machine has abnormal problems in the process of using it. Then the production operation should be stopped immediately. And the equipment for problem detection and troubleshooting. So as not to cause unnecessary losses. Then the following is a summary of impact sand making machine manufacturer problems and solutions.

Sand making machine vibration amplitude abnormally large
If the feeding material produces a large vibration amplitude in the sand making machine. If there is an abnormally large amplitude. Then you need to check the feed particle size of the material. If the feed grain size is too large, it will also appear such as excessive amplitude. If the impeller inside the sand making machine is worn out. It will also cause abnormal vibration of the equipment. We need to check the wear and tear of the impeller and alloy hammer head of the sand making machine. If there is damage, then we need to replace the impeller in time. There is also a kind of other willingness. It is the ground angle bolt if it appears to be loose. Then you need to reinforce it.

Sand making machine discharge finished product is too large
If the size of the discharged material is too large. Then you need to check the wear and tear of the hammer head and the impact plate inside the sand making in. It is necessary to repair the alloy hammer head and side impact plate. If the wear is too serious. Then it needs to be replaced with a new one. Sand making machine sand granularity. It is an important factor that directly affects the production capacity of the sand making machine. If the particle size is too large, it will be too large for the brick making machine discharge size.

Sand making machine bearing heat
If there is a lack of lubricating oil or too much oil is added to the bearings of the sand making machine, it will cause the bearings to heat up. It will cause the bearing to heat up. It is necessary to check the amount of oil. If the bearing is damaged or hot. It is necessary to disassemble and replace the bearings. If the upper cover of the upper part of the sand making machine bearing body is too tight. Then you need to adjust the bolt to loosen it appropriately. There is also a situation where the idling resistance of the sand making machine is too large. It may be that other foreign objects enter into the bearing sealing cover, then you need to clean up the raw materials and foreign objects in the sand making machine. If the bearing can not work flexibly. Then you need to increase the idling resistance of the sand making machine.

The above mentioned are the common problems and solutions of the impact sand making machine in the production process. If there is any abnormality, please stop the machine immediately for maintenance and inspection. Avoid damage to other internal parts.